• Remote power on / off / reboot control for eight outlets via TCP/IP and a built in RS-232 PON (Power Over the NET™) port
• Local power on / off / reboot control via the PN0108's PON port to the computer's RS-232 port
• Daisy chain up to 15 additional stations to control up to 128 outlets
• Manual switching between Local and Remote access for each port via front panel push button switches
• Individual control of each port - users can set the power on sequence and delay time for each port to allow equipment to be turned on in the proper order
• Easy setup and operation via a GUI interface
• Provides three configuration/management methods: Browser; Telnet; or Console Terminal
• Safe shutdown and rebooting for Windows systems*
• Overcurrent protection and recovery for each AC port (110 V model only); total port overcurrent protection (both models) - remote users can monitor the outlet status via the GUI interface
• Separate circuits for the unit's power and the power to the devices - the power control status menu is still accessible even when an overcurrent condition trips the devices' circuit breaker
• On/Off scheduling - allows everything from a one-time start/shutdown, to daily, weekly, etc. starts/shutdowns at user-specified times
• Port grouping - perform the same action on a specified group of ports
• LEDs for easy status monitoring
• Two level (Administrator and User) security
• Configuration can be reset
• Firmware upgradeable - daisy chained stations receive the upgrade via the daisy chain bus
• UL/TUV approved
• Multiplatform support: Windows 2000/XP/Vista, Linux, Unix and FreeBSD.
*Safe shutdown and rebooting is supported if the Power Monitor utility has been installed
• For more information about KVMs which can connect to PN0108, see
Compatible KVM Table*The PN0108 is not a stand-alone unit. It must be connected to the CN6000, PN9108, SN0108 or SN0116 to access these features
